Compact key programmer for Fiat, Ducato, Ford Ka, Grande Punto

Description

Compact key programmer for Fiat supports such models:

How to prepare the transponder?

First you have to specify 0 keys via DIP switches 1-4 on position off

Once you are ready position the transponder perpendicularly to the ring of the antenna. Then put the device in the OBDII and wait for the initialisation (3 flashes in green). The procedure itself takes a few seconds. After a successful transponder preparation, the LED flashes slowly green, otherwise flashes red quickly.

Step 2: Key learning

Start by specifying the number of keys to be learned via DIP switches 1-40 keys – a special case when the transponder is prepared only, as described in section 1 1 key – on, off, off, off 2 keys – off, on, off, off 3 keys – on, on, off, off 4 keys – off, off, on, off 5 keys – on, off, on, off 6 keys – off, on, on, off 7 keys – on, on, on, off 8 keys – off, off, off, on Put the device in the OBDII and wait for initialisation (3 flashes in green). The LED does not light for 5 seconds. The LED lights in red for 10 seconds – the ignition should be turned ON with each next key.

• After 10 seconds in ignition ON the LED lights in green for 5 seconds – the key is accepted.
• After 10 seconds in ignition ON the LED is blinking slowly in red for 5 seconds – the key is not accepted, the procedure should be repeated!

Until all keys are accepted, the result is not recorded!!! At the end the LED is blinking slowly in green (if it did not get stuck in the preparation of the key).

You can see here “VAG MQB key programming device“.

IMPORTANT !!! WE SELL ALL DEVICES FOR OFFICIAL USE ONLY !!!
!!! THE MANUFACTURER IS NOT RESPONSIBLE FOR ILLEGAL ACTIONS BY THE BUYERS !!!